Jeff V
- Total activity 16
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 4
Activity overview
Latest activity by Jeff V-
Jeff V commented,
A happy update for me... I saw a firmware update last night, installed it and decided to give it yet one more try. To my surprise, it is working now. I seriously doubt it was this firmware update...
-
Jeff V commented,
Unfortunately, I've tried everything I can think of and have had zero success. I've just given up hope that I'll ever be able to open my garage door using Google... boo!
-
Jeff V commented,
No luck with that either. I'm still at square one unfortunately... "huh, looks like there's a problem."
-
Jeff V commented,
No difference with send to device... same error. Unlinking seems to have caused more issues. After unlinking, a had to of course re-add it in Google again for Assistant to see it; however, creatin...
-
Jeff V commented,
Good idea... tried that but no luck.
-
Jeff V commented,
You could easily cut and splice in as much additional wire length as you need unless I'm misunderstanding
-
Jeff V created a post,
Google Home Integration
For some reason every time I try to open my garage with Google Assistant, it reports an error after I provide my pin code. "Huh, looks like there's a problem." Closing it and asking if it's open/cl...
-
Jeff V commented,
Sure... I have a Genie Excelerator. To use the existing close limit switch, I cut off the magnetic switch that came with the Tailwind device, leaving a couple of feet of wire. I put the black wire ...
-
Jeff V commented,
Thanks for the helpful info. My garage unit was just under 5 volts so I installed it with the existing limit switch no problem... Yay for a 5 minute install with virtually no wires!
-
Jeff V created a post,
Open/Close Switch
Would it be possible to use the existing open/close garage door sensors in parallel rather than installing a separate set of switches? Without knowing the internal circuitry of the iQ3, I would ass...